Introduction - Kaba Mas DKX Series Installation Instructions Manual

INTRODUCTION

The Kaba Mas DKX-10 Type III is General Services Administration (GSA)
approved. It complies with Federal Specification FF-L-2890C. The DKX-10 Type
III comes with a modified Kaba Mas CDX-10. The DKX-19, Type III option comes
with a modified S&G 2740 combination lock in place
of the X-10.
Please read all directions carefully.
These instructions are designed for use by technicians and locksmiths familiar
with common safety practices and competent to perform the
steps described.
Caution: Kaba Mas is not responsible for damage or malfunction due to
incorrect installation.
Notes:
1. Carefully inspect doorframe, door, and hinges to ensure the door and
frame fit and operate correctly.
2. The installer should ensure that the door meets all building, fire, and
security code requirements prior to installing the
DKX-10 Type III.
3. Kaba Mas recommends the installer of the DKX-10 is properly trained
on the Kaba Mas DKX-10 Type III, Pedestrian Door Lock. (Contact Kaba
Mas at 859-479-1329 for DKX-10 Certification Training and training
dates.)
4. The Kaba Mas X-10 is protected from Electrostatic Discharge (ESD).
However, it can be damaged during the installation process if proper
precautions are not taken. Follow these precautions to avoid ESD
damage when installing a modified CDX-10 High Security Lock.
A. For best protection, use an ESD wristband
grounded to the lock during installation.
B. Do not touch the end of the flex cable if the
ESD protective cover has been removed.
4
4