Table of Contents
Advertisement
Install Panic Bar and Rail Assembly to Door
A.
Remove two 8-32 screws from chassis.
B.
Loosen screws securing chassis and
C.
Secure chassis mounting screws.
D.
Remove protective covering from the panic bar and rail assembly prior to installing on door.
E.
Hold rear mounting bracket tightly against door and rear of rail.
F.
Assure panic bar is level.
G.
Mark (2) holes and drill.
H.
Secure with proper fasteners.
Figure 5
Install End Cap
A.
Attach end cap with (2) screws
Figure 6
General Maintenance Notes
The dormakaba DKX Series Exit Devices are designed to give years of trouble-free service, however, depending on
installation, location, climate conditions, etc., routine maintenance is recommended in all latch bolt locations. The
device should be periodically cleaned and re-lubricated with Dura-Lube or equivalent to ensure proper function of all
moving parts.
slide panic bar and rail assembly under rear of chassis.
25
25
Advertisement
Table of Contents
