Table of Contents
Advertisement
Install Lock Cable Assembly
A.
Ensure correct assembly of the rod end connector (515040 or 515029), jamb nut (115123) and cable subassembly (116036).
Note: Do not tighten the jamb nut down on the connector rod until the optimum timing is achieved in opening the DKX-10 or DKX-19
high security lock.
B.
Attach this subassembly to the cam lever (515027) with the retaining clip (515041).
C.
Refer to Figure 23 or Figure 24 depending on the handing of the installation.
D.
Use lubricant (9810004) to adequately grease all moving parts on both RHR and LHR cable/cam and levers. A generous
application of grease is recommended.
Figure 23
Figure 24
33
Figure 23 (RHR Application Shown)
Figure 24 (LHR Application Shown)
33
Advertisement
Table of Contents
