Related Manuals for Kaba Mas CDX-10
Summary of Contents for Kaba Mas CDX-10
- Page 1 CDX-10™ INSTALLATION & OPERATING INSTRUCTIONS Please read all instructions carefully before putting your CDX-10 into operation.
-
Page 3: Table Of Contents
LIFE SAFETY OPERATION ................. 5 CDX-10 INSTALLATION ............... 6 BASIC TOOLS NEEDED ................6 INSTALLATION KIT CONTENTS..............7 CDX-10 PARTS FOR INSTALLATION ............8 STRIKE INSTALLATION ................9 TEMPLATE ....................9 DEAD BOLT INSTALLATION ............... 9 DIAL RING INSTALLATION ............... 10 CUSTOM TUBE AND SPINDLE CUTTING .......... -
Page 4: Introduction
INTRODUCTION The combination door unit can be added to the X-10 lock to form the CDX-10. This adaptation allows you to have access control on any door. CDX-10 OPERATING INSTRUCTIONS NOTE: Read all instructions carefully before attempting to INSTALL and operate your CDX-10 Lock Assembly. -
Page 5: To Open From Inside
TO OPEN THE CDX-10 FROM THE INSIDE 1. Turn the release knob to the left (counterclockwise) to withdraw the dead bolt. LIFE SAFETY OPERATION The Life Safety Feature (Bolt Stop Assembly) is provided to prevent someone from unintentionally extending the lock bolt. -
Page 6: Cdx-10 Installation
CDX-10 Installation Instructions Please read all instructions carefully before you install and use your CDX-10 Lock Assembly. This will help you avoid unnecessary costs and concerns resulting from improper installation. BASIC TOOLS NEEDED 1. Medium Phillip’s screwdriver (#1/#2). 2. Standard hacksaw (32 teeth/inch). -
Page 7: Installation Kit Contents
*The Zebra Connector and Zebra Connector Housing are assembled at the factory but may come apart during shipment. 14. CDX-10 to door mounting screws, pan head #10 x 1.25, Type AB (2) - not shown. 15. Dial ring to exterior mounting plate mounting screws, pan head #8-32 x 5/16 (2) (Packaged with exterior mounting plate - used with exterior mounting plate) - not shown. -
Page 8: Cdx-10 Parts For Installation
CDX-10 PARTS FOR INSTALLATION 1. CDX-10 Dead bolt lock assembly 2. CDX-10 Base hardplate 3. Dial hub assembly 4. Strike Kit (1 of 4 Types: 1, 2, 3 or 9; Strike #9 is shown in photo with screws) 5. Spindle 6. -
Page 9: Strike Installation
10. Place the 3.5 X 5 x 1/8" hardplate against the back of the CDX-10 base. 11. Feed the cable and outer tube through the 1/2" hole in the door while positioning the CDX-10 and hardplate against the door. -
Page 10: Dial Ring Installation
Please note that when those instructions refer to the lock case assembly, the installer should consider that as meaning the CDX-10 unit. DO NOT REMOVE THE X-10 LOCK CASE FROM THE CD BASE. (P/N) 541.1212 Rev B 07/15 • © copyright 2012-2015... - Page 12 NOTICE: The information in this manual is subject to change without notice and does not represent a commitment on the part of Kaba Mas. Kaba Mas shall not be liable for technical errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance or use of this material.