Test The Movement Of The Lever (Without The Key In Cylinder); Test The Mechanical Key Override With Change Key - Kaba Mas DKX Series Installation Instructions Manual

Test the Movement of the Lever (without the key in
cylinder):
A. Turn the lever (h) clockwise for a right-handed lock or
counterclockwise for a left-handed lock.
B. Release the lever slowly. It should return freely to its
horizontal position.

Test the Mechanical Key Override with Change Key

Important: The key override itself does not retract the latch or deadbolt. Do not
use too much force when turning the key as this may damage the unit. To retract
the latch, turn the key clockwise until it stops, release the key and turn the lever.
Note: The lever must stay in the horizontal position when turning
the key (Do not try to turn the key while turning the lever.) or the
override mechanism will not work.
A. Without using the key, turn the lever clockwise for right-
handed locks or counterclockwise for left-handed locks. The
inside drive hub should not rotate when the lever turns.
B. With the lever (h) in the horizontal position, insert the key
(n) into the cylinder and turn it clockwise until it stops. (This
applies to both right and left-handed locks.)
C. Let go of the key, and again turn the lever handle
(h) clockwise for right-handed locks or counterclockwise for
left-handed locks. Now the inside drive hub (b) should
rotate in the same direction as the lever handle when it is
turned.
19
Figure 16
Figure 17
19