Table of Contents
Advertisement
J.
Feed the cables and outer tube through the .500"-inch hole in the door while positioning the DKX-10 and backing
plate against the door. Insert and tighten slightly two #10-32 screws nearest the strike opening (top and bottom) to
attach the DKX-10 and backing plate to the door.
Helpful Hint: If available, another inner tube inserted from the dial ring side, with the cables carefully fed through it, can be
very helpful as a guide in feeding the cables through the door face.
Install the Dial Ring
A.
Remove the two screws from the dial ring assembly cover and remove the cover.
Note: Make sure the tubes are projecting through the door. If not, the tubes are not
seated properly in the lock or they were not cut to the proper length. Correct the
problem before proceeding.
B.
If necessary, rotate the tube retainer in the dial ring so that the
cables come through the notch in the tube retainer.
C.
Feed the cables through the tube retainer on the dial ring assembly and
place the dial ring assembly over the end of the tubes. Make sure the
tubes are seated in the tube retainer on the dial ring assembly.
D.
Attach the dial ring to the door with the dial ring mounting screws and
tighten to the specified torque.
Install the Cables
A.
Open the ZIF (Zero Insertion Force) seal cover and move the ZIF
connector locking actuators outward to their open position.
B.
Plug the cables into the ZIF connectors with the bright metal tabs on the
cables facing toward the circuit board to which the ZIF connectors are
mounted.
C.
Push the cables into the connectors as far as they will go.
D.
Close the ZIF locking actuators to lock the cables in place.
E.
Close the seal cover and ensure the tenons in the seal cover align with the holes in the coordinating piece of the
seal cover.
Figure 8
6
Closed
Open
Closed and Open ZIF Connectors
Figure 10
LCD and ZIF Connectors
6
Figure 9
Seal Cover
6
ZIF Seal Cover (shown closed)
29
Figure 7
6
29
Advertisement
Table of Contents
