Table of Contents
Advertisement
Change BEST-Type Core
A.
Use the control key to remove the removable
core from the lever.
B.
Remove the adapter from the removable core
and reassemble it on the new removable core.
Note: It is important that the new removable core has the same number of pins
(6 or 7) as the dismounted one. If not, change the adapter to fit the core.
C.
Check to make sure that the override shaft did
not move and that the 2 small indents on
override shaft are still vertical. (See Figure 21.)
Then using the control key on the new core,
assemble the new removable core on the lever.
D.
Test the locks as per Test the Operation of the
Outside Lever, and Test the Mechanical Key
Override with Change Key instructions on pages
17-18.
Remove and Reassemble the Outside Lever
A.
Loosen the set screw to free the lever
lever. (just
B.
Insert the change key in the cylinder.
C.
Turn the key clockwise until it stops. (for
both right and left-hand locks)
D.
Release the key.
E.
Use a small flat screwdriver to push in the lever
catch through the small hole underneath the
outside lever.
F.
Pull the outside lever off of the lock housing.
Be careful not to lose the adapter.
Important: Assemble the lever, cylinder and lock components before affixing the
entire unit to the door.
1
1
/
to
/
turn)
4
2
Figure 20
21
21
Advertisement
Table of Contents
