Jeep Wrangler 2020 Owner's Manual page 370

368 STARTING AND OPERATING
3. At the next vehicle stop (after turning off the Stop/Start
system), the engine will not be stopped.
4. If the Stop/Start system is manually turned off, the
engine can only be started and stopped by cycling the
ignition switch.
5. The Stop/Start system will reset itself back to an ON condi-
tion every time the ignition is turned off and back on.
To Manually Turn On The Stop/Start System
Push the Stop/Start OFF switch (located on the switch bank).
The light on the switch will turn off.
System Malfunction
If there is a malfunction in the Stop/Start system, the system
will not shut down the engine. A "SERVICE STOP/START
SYSTEM" message will appear in the instrument cluster
display. Refer to "Instrument Cluster Display" in "Getting to
Know Your Instrument Panel" for further information.
If the "SERVICE STOP/START SYSTEM" message appears
in the instrument cluster display, have the system checked
by an authorized dealer.
SPEED CONTROL — IF EQUIPPED
When engaged, the Speed Control takes over accelerator
operations at speeds greater than 20 mph (32 km/h).
The Speed Control buttons are located on the right side of the
steering wheel.
Speed Control Buttons
1 — SET (+)/Accel
2 — On/Off
3 — RES/Resume
4 — SET (-)/Decel
5 — CANC/Cancel