Jeep Wrangler 2020 Owner's Manual page 331

If the vehicle is not in PARK and the driver turns off the
engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with an 8-speed transmission
• Drivers door is ajar or in conditions where driver door is
removed an additional trigger would be if the driver is off
the seat (seat pad sensor detects driver missing).
• Vehicle is not in PARK
• Vehicle speed is 0 mph (0 km/h)
• Ignition switched from RUN to OFF
NOTE:
For Keyless Enter-N-Go equipped vehicles, The engine will
turn off and the ignition switch will change to ACC mode.
After 30 minutes the ignition switches to OFF automatically,
unless the driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits the
vehicle with the engine running, the vehicle may Auto-
Park.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with an 8-speed transmission
• Drivers door is ajar or in conditions where driver door is
removed an aditional trigger would be if the driver is off
the seat (seat pad sensor detects driver missing).
• Vehicle is not in PARK
• Driver's door is removed
• Vehicle speed is 1.2 mph (2.0 km/h) or less
• Driver's seat belt is unbuckled
• Driver's door is ajar
• Brake pedal is not depressed
The MESSAGE "AutoPark Engaged Shift to P then Shift to
Gear" will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be displayed in the
instrument cluster. In these cases, the shifter must be
returned to "P" to select desired gear.
STARTING AND OPERATING 329
5