Freedom Top Three-Piece Modular Hard; Top - If Equipped - Jeep Wrangler 2020 Owner's Manual

Step Seven
8. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective cover
for shipping only.
NOTE:
A visual instruction sheet is included with the vehicle.
9. Raise the soft top. Refer to "Raising The Soft Top" in this section.
NOTE:
Be sure the wire harness in the left rear corner is not tangled
in the soft top bows before you lift the top.
GETTING TO KNOW YOUR VEHICLE

FREEDOM TOP THREE-PIECE MODULAR HARD

TOP — IF EQUIPPED
CAUTION!
• The hard top is not designed to carry any additional
loads, such as after-market roof racks, spare tires,
building materials, hunting or camping supplies, etc.
For optional Mopar accessory roof racks, refer to the
Roof Luggage Rack portion of this Owner's Manual for
additional information.
• Do not move your vehicle until the top has been either
fully attached to the front header, sport bar, and body
side or fully removed.
Failure to follow these cautions may cause interior water
damage, stains or mildew:
• It is recommended that the top be free of water prior to
panel removal. Removing the top, opening a door or
lowering a window while the top is wet may allow
water to drip into the vehicle's interior.
• The hard top assembly must be positioned properly to
ensure sealing. Improper installation can cause water to
leak into the vehicle's interior.
103
2
(Continued)