Jeep Wrangler 2020 Owner's Manual page 178

176 GETTING TO KNOW YOUR VEHICLE
CAUTION!
Failure to follow this step will cause damage to the
vehicle's header seal.
2. Manually remove the protective caps over the windshield
wiper hex bolts.
Protective Cap Over Wiper Bolt
3. Using the provided 15mm socket, remove the two hex
bolts and remove the wiper arms.
4. Move to the inside of the vehicle and lower both sun
visors.
5. Using the provided #40 Torx head driver, remove the
four Torx screws located along the interior of the wind-
shield.
Interior Torx Screw Locations
NOTE:
Store all of the mounting bolts in their original threaded
holes and tighten for safekeeping.