Power Top Maintenance; Ignition Off Operation; Relearn Procedure - Jeep Wrangler 2020 Owner's Manual

170 GETTING TO KNOW YOUR VEHICLE

Power Top Maintenance

Use only a non-abrasive cleaner and a soft cloth to clean the
quarter window glass panel.
Refer to "Bodywork" in Servicing And Maintenance" for
further information. It contains important information on
cleaning and caring for your vehicle.

Ignition Off Operation

The power top switch can remain active in Accessory Delay
for up to approximately 10 minutes after the vehicle's igni-
tion is placed to the Off position. Opening either front door
will cancel this feature.
NOTE:
Ignition Off time is programmable through the Uconnect
System. Refer to "Uconnect Settings/Customer Program-
mable Features" in "Multimedia" for further information.

Relearn Procedure

For vehicles equipped with a power top, there is a relearn
procedure that allows you to calibrate the power top when
the "Express Mode" stops working. To reset the power top,
follow these steps:
1. Place the ignition in the RUN position, and start the
vehicle.
NOTE:
The engine must be running to perform the relearn proce-
dure.
2. Ensure the power top is in the fully closed position.
3. Push and hold the Close switch for 10 seconds. This will
put the power top into calibration mode.
4. Continue holding down the close button while the top
goes fully open and then back to fully close.
5. Once the power top has stopped in the fully closed posi-
tion, release the close button. The power top is now reset
and ready to use.