To Arm The System; To Disarm The System - Jeep Wrangler 2020 Owner's Manual

32 GETTING TO KNOW YOUR VEHICLE

To Arm The System

Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicle's ignition is cycled to the OFF posi-
tion. Refer to "Starting The Engine" in "Starting And
Operating" for further information.
2. Perform one of the following methods to lock the vehicle:
• Push lock on the interior power door lock switch with
the driver and/or passenger door open.
• Push the lock button on the exterior Passive Entry Door
Handle with a valid key fob available in the same exte-
rior zone. Refer to "Keyless Enter-N-Go — Passive
Entry" in this chapter for further information.
• Push the lock button on the key fob.
3. If any doors are open, close them.

To Disarm The System

The vehicle security alarm can be disarmed using any of the
following methods:
• Push the unlock button on the key fob.
• Grasp the Passive Entry Unlock Door Handle (if
equipped), refer to "Keyless Enter-N-Go — Passive Entry"
in this chapter for further information.
• Cycle the vehicle ignition system out of the OFF position.
NOTE:
• The driver's door key cylinder cannot arm or disarm the
vehicle security alarm.
• When the vehicle security alarm is armed, the interior
power door lock switches will not unlock the doors.
The vehicle security alarm is designed to protect your
vehicle. However, you can create conditions where the
system will give you a false alarm. If one of the previously
described arming sequences has occurred, the vehicle secu-
rity alarm will arm regardless of whether you are in the
vehicle or not. If you remain in the vehicle and open a door,
the alarm will sound. If this occurs, disarm the vehicle secu-
rity alarm.