Jeep Wrangler 2020 Owner's Manual page 23

Battery Replacement
3. Install the new battery into the key fob, making sure the
positive (+) side is facing up. Slide the battery until it is
seated securely below the tabs.
4. Reassemble the back cover making sure it is properly
aligned before snapping it back in place.
GETTING TO KNOW YOUR VEHICLE
Programming Additional Key Fobs
Programming the key fob may be performed by an autho-
rized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it cannot be
repurposed and reprogrammed to another vehicle.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the vehicle electronics
can be used to start and operate the vehicle. Once a key fob
is programmed to a vehicle, it cannot be programmed to any
other vehicle.
WARNING!
• Always remove the key fobs from the vehicle and lock
all doors when leaving the vehicle unattended.
• Always remember to place the ignition in the OFF mode.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank key
fob to the vehicle electronics. A blank key fob is one that has
never been programmed.
21
2