PCB ERS LAMP
1. Open the Cover jam access. (See "ROLLER TRANSFER ASSY/GUIDE TRANSFER" on page 5-42.)
2. Remove the Printer fuser. (See "PRINTER FUSER" on page 5-55.)
3. Remove one screw [1].
4. Remove the Spring C stopper JAC [2], then remove the Cover jam access [3].
5. Disconnect the connector [4].
6. Remove one screw [5], then remove the Bracket PCB LED [6].
[ 4 ]
[ 6 ]
[ 5 ]
[ 1 ]
[ 2 ]
[ 3 ]
7. Pull out the PCB ERS LAMP [7] from the Bracket PCB LED [6].
[ 6 ]
[ 7 ]
5-70