Konica Minolta BIZHUB 25E Field Engineering Manual page 80

3.2.2 Clearing the machine parameters
Resets the machine parameters to factory defaults.
1. From standby, press <Mode>, <*>, <0>, <0>.
2. Press [Clear Parameters].
3. Press [Yes]. The machine parameters will reset to factory defaults.
3.2.3 List
• Image data output level (Data attenuation)
• URADF, Scanning start position adjustment (Horizontal) /Back
• URADF, Elastic rate adjustment (Horizontal) /Back
• URADF, Scanning start position adjustment (Vertical) /Back
• URADF, Scanning end position adjustment (Vertical) /Back
• URADF, Scanning start position adjustment (Horizontal) /Front
• URADF, Elastic rate adjustment (Horizontal) /Front
• URADF, Elastic rate adjustment (Vertical) /Front
• URADF, Scanning start position adjustment (Vertical) /Front
• URADF, Scanning end position adjustment (Vertical) /Front
• FBS, Scanning start position adjustment (Horizontal)
• FBS, Elastic rate adjustment (Horizontal)
• FBS, Elastic rate adjustment (Vertical)
• FBS, Scanning start position adjustment (Vertical)
• Duplex scan length adjustment
• Mirror carriage standby position adjustment
• Background level adjustment starting position
• Loop volume adjustment at DRS sensor
• Paper loop volume adjustment
• Density adjustment
Adjustment
3-4
Parameter
001
030
031
033
034
035
036
037
038
039
040
041
042
043
056
060
064
066
260
301 ~ 357