Communication Tourble - Konica Minolta BIZHUB 25E Field Engineering Manual

4.4 Communication tourble

4.4.1 Fax communication error
Deatail error code are printed on T.30 monitor.
Detail
Phase Error code
Error code
Tx Phase A D.0.1 0001
D.0.2 0002
D.0.3 0003
D.0.7 0007
D.0.8 0008
Tx Phase B T.1.1 1011
T.2.1 1021
T.2.2 1022
1100
1101
1102
1103
1104
1105
1109
110A
110B
110C
110D
Description
Local busy detection. No
Busy Tone detected
Canceled transmission while dialing
Receiver does not answer
Can not detect dial tone
T1 time-out error Yes
Can not detect CFR or FTT
Compatibility error
Password transmission failed
Cannot obtain password at
password transmission from
receiving party
The obtained password from
receiver at password transmission
is blank
The receiver is a product of other
maker at closed communication
The receiver has no pass code field
at closed transmission
The pass code did not match at
closed transmission
Cannot adjust communication data
rate
Cannot adjust the communication
mode (Normal, fine, super fine)
Cannot receive standard frame
DIS T4 bit did not turn ON
DIS or DTC that FIF is 00 00 00
has been received. DTS requires
hang up. German models only.
Journal Redial
Yes The sending was stopped. Please try again.
The line was busy. Please try again.
No Fax job was cancelled by user.
Yes Check condition of remote fax.
No dial tone detection. Check line connection.
Only Confirm the remote fax.
when one
or more
pages are
received
No Confirm the remote fax.
Confirm the remote fax.
ID check Tx error. ID was not matched.
ID check Tx error. No fax number stored in remote
fax.
Close Tx error. Remote fax is not compatible.
Close Tx error. No pass -code stored in remote fax.
Close Tx error. Passcode unmatched.
Confirm the remote fax.
Confirm the remote fax.
Confirm the remote fax.
4-6
Message
Occurs at broadcast with
TCR.
Normally, this error does
not occur.
Normally, this error does
not occur.
Note