Network Capture (Packet Capture) - Konica Minolta BIZHUB 25E Field Engineering Manual

Printer control parameter 064 ~ 068 :
Initial
bit
Setting
7 0
6 0
5 0
4 * Tray number command
3 *
for PS3
2 *
1 *
0 *

3.31 Network capture (Packet capture)

You can capture the packet data the machine has sent and received. When you read the data using a pack-
et analyzing tool such "tcpdump" or "Wireshark" , you can use it as a subsidiary tool to detect the cause of
transmission problem.
There are two ways to capture the packet data: capturing from web browser (see "3.42.6 Network capture"
on page 3-130) and from the machine control panel. When you operate it from the machine, the captured
data will be stored in the USB memory. You can output data captured on the panel from the panel only to
the panel, and from web output to web only.
3.31.1 Setup
Set up the following items to use this function. This step is required only for the first time when you use this
function.
Host
Protocol
Port
Count
Size
1. Press <Mode>, <*>, <5>, <8>.
2. Press [Capture Settings].
3. Set up the detailed capture setting.
Adjust
Set the tray number command for PS3.
0 to 23 are available. Other values have no operation
guarantee.
To enable this setting, turn printer parameter 27 bit 4 to "1".
Printer control parameter 064: Bypass tray (default 0)
Printer control parameter 065: Cassette 1 (default 1)
Printer control parameter 066: Cassette 2 (default 2)
Printer control parameter 067: Cassette 3 (default 3)
Printer control parameter 068: Cassette 4 (default 4)
All : To capture the packets between the machine and all hosts, select [ON].
IP Address : To capture the packets between the machine and specific host, select
[OFF] at "All". Then, enter the host name in the "Host" field". You can
enter only IP address when you enter it from the machine control panel.
Select the protocol to capture. You can select multiple protocols.
Enter the port number to capture.
Enter the number of packets to capture. Capturing stops automatically when it
reaches this number.
When you enter 0, you can capture the packets using the USB memory device until
you press [Stop].
Enter how many bites to store for each packet.
You can enter number from 64 to 1514 bites.
Usage/Comments
3-111