Konica Minolta BIZHUB 25E Field Engineering Manual page 124

3.5.2 Clearing the unique switches
Resets the unique switches to factory defaults.
1. From standby, press <Mode>, <*>, <0>, <4>.
2. Press [Switch Clear].
3. Press [Yes]. The unique switches will reset to factory defaults.
4. Press <Reset> to return the machine to standby.
3.5.3 List
• Congestion tone detection
000
• Enable the first tone key
001
• Enable the second tone key
• Enable the dial prefix key
• Display only direct input number on redial list
003
• The period before detecting busytone after dialing
• I ncluding TTI inside the document
010
• T he number of times PPR is detected during ECM transmission
• Encoding method for transmission
013
• Returns from V28 to V8
015
• V.8 handshake in real time Tx
• JBIG transmission
017
• Disconnect the line when the transmission speed falls down under
018
7200 bps
• Disconnect the line when the transmission speed falls down under
4800 bps
• Transmission when disable to detect first NSF in real time transmis-
sion
• Number of redial times for archive transmission
019
• Transmit CED signal
020
• Printout the pages completed to receive during receiving into memory
• TCF check time (in 100 ms units)
021
• Document storage method
022
• MMR reception
• JBIG reception
• Encoding method for reception
023
• Displays the message "No Network Connection."
029
• 3429 baud symbol rate when communicating at V.34
030
• 3200 baud symbol rate when communicating at V.34
• 3000 baud symbol rate when communicating at V.34
• 2800 baud symbol rate when communicating at V.34
• 2400 baud symbol rate when communicating at V.34
• ANSam output time
032
• Reception level at CED 2100 Hz
035
• The timing between V.34 handshake signals
037
• Smooth printing for printing normal document
050
• Give priority to "fit to paper"
051
• Printing margin adjustment
052
3-48