Advertisement
Introduction
1.1
Preliminary information
Purpose of this documentation
This documentation provides you with an overview of the configuration, parameter
assignment and programming of the RF290R reader. The programming manual is intended
for users and programmers involved in configuration, commissioning and servicing of the
RF290R.
To configure the RF290R, you require knowledge of the following:
● Structure of the system (e.g. components used, in particular the transponders)
● Basic knowledge of RFID
Range of validity of this documentation
This documentation is valid for all supplied variants of the RF290R and describes the
RF290R as delivered from March 2013 onwards.
Registered trademarks
SIMATIC ®, SIMATIC RF ®, MOBY ®, RF-MANAGER ® and SIMATIC Sensors ® are
registered trade marks of Siemens AG.
1.2
General information and abbreviations/acronyms
General information on this document
● If individual bits in a byte are shown as "-", the bit positions are reserved for future
expansion or for internal test and manufacturing functions. These bit positions must not
be changed since this can cause incorrect operation of the reader.
● The following number formats are used:
– 0...9: for decimal numbers
– 0x00...0xFF: for hexadecimal numbers
– b0...1: for binary numbers
● The hexadecimal value in brackets "[ ]" indicates a control byte (command).
RF290R
Configuration Manual, 09/2014, C79000-G8976-C377-01
1
7
Advertisement
