Hexadecimal
value
0x01
0x02
0x03
0x04
0x05
Hexadecimal
value
0x10
0x11
0x13
0x14
0x15
0x16
RF290R
Configuration Manual, 09/2014, C79000-G8976-C377-01
Transponder status
No transponder:
No transponder within the detection field of the reader
•
Transponder in detection field has been switched to silent
•
Disruption in communication between reader and transponder. The reader
•
can no longer detect the transponder.
incorrect data:
CRC16 checksum error in the received data
•
Write error:
Plausibility test of written data failed:
Attempt to write to a read-only area (only I-CODE1 and Tag-it RF transpond-
•
ers)
Distance between transponder and reader antenna too great
•
Attempt to write during excessive ambient noise
•
Address error:
The requested data is outside the logical or physical address range of the tran-
sponder:
The address is outside the maximum address range of the transponder.
•
The address is outside the configured address range of the transponder.
•
wrong transponder type:
This command is not supported by this transponder:
A specific command is not supported by the transponder.
•
Parameter status
EEPROM error:
EEPROM of the reader cannot be written to
•
Before the write procedure in the EEPROM, a parameter checksum error
•
occurred.
Parameter outside the valid range:
Valid parameter range exceeded
•
Login required:
Access to the configuration without first logging in
•
Login error:
Attempt to log in with the wrong password
•
Read protection:
Configuration block reserved for future use
•
Write protection:
Configuration block reserved for future use
•
Appendix
A.4 Index of the status bytes
105