Safety Signs; Product Identification Label; Main Components - Stiga BC 25 H Operator's Manual

3.2 SAFETY SIGNS

The machine has various symbols on it
(Fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
WARNING! DANGER! The failure
to use this machine correctly can be
hazardous for oneself and others.
WARNING! Read the instruction
manual before using the machine.
Anyone operating the machine
under normal conditions for
continuous daily use may be
exposed to a noise level equal
to or exceeding 85 dB (A). Wear
ear protectors, safety goggles
and a protective helmet.
Wear gloves and safety boots!
PROJECTION HAZARD! Keep
people or pets at least 15 m
away when using the machine!
Maximum cutting means speed.
Do not use circular saw blades.
Danger: Using circular saw
blades on models that are not
designed for them exposes
the user to the danger of very
serious or even fatal injuries.
WARNING! Petrol is flammable.
Allow engine to cool at least 2
minutes before refuelling.
Beware of blade thrust.
WARNING! - Keep away
from hot surfaces.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label provides
the following data (Fig. 1):
1. Sound power level
2. Conformity marking
3. Month/Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever
you contact an authorised service centre.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig. 1 ):
A. Engine: drives cutting means motion via the
transmission tube and angle transmission.
B. Transmission tube: the transmission
shaft is lodged inside and transmits rotary
motion to the angle transmission.
C. Angle transmission: final part of
the transmission tube that transmits
motion to the cutting means.
D. Cutting means: the element
designed to cut vegetation
1. Cutting line head: nylon
line cutting means.
EN - 5