Electrical Connection; Connection To The Electrical Network (Vac) - Optional - Vitrifrigo DRW Sereis Installation Use And Service Manual

6 ELECTRICAL CONNECTION

6.1

Connection to the electrical network (VAC) - optional

The refrigerator connects to the electrical network by plugging it into an electrical socket. If the plug is
not present replace the socket with a suitable one. This operation must be done by a suitably qualified
person who must ensure that the cable section of the plug is appropriate to the power absorbed by the
appliance.
The power outlet must be firmly installed and appropriately earthed.
Check that the voltage and the frequency correspond to the refrigerator's nominal data as shown on the
product label. Connection is via a power cable with plug supplied. The voltage must not undergo
variations greater than ± 5%.
Provide a differential thermal-magnetic breaker switch (IΔn=0.03 A), 6A, type C. The remote switch must
disconnect all the poles from the electrical supply, must guarantee an opening of at least 3mm and must
be safe in the event that the electricity is accidentally reactivated. In the case of any doubt, consult a
suitably qualified technician.
Run the electrical cables in such a way as to avoid any risk of tripping or of causing damage.
The electrical cable must not come into contact with any part that could reach a temperature greater than
50°C.
Before connecting the product, make sure that the voltage corresponds to that shown on the identification
label or that shown on the label on the compressor.
IMPORTANT: by law, the equipment must be earthed.
Make sure that the earthing system for the electrical network is working perfectly.
We accept no responsibility whatsoever for any injury to people or damage to property deriving
from the failure to properly comply with this regulation.
The use of adaptors, multiple sockets and extension cords is not recommended.
Fig. 6.1
Fig. 6.2
47
EN