Setting The Operation Mode / All In One; Changing The Temperature Setting - Vitrifrigo DRW Sereis Installation Use And Service Manual

7.3

Setting the operation mode / All in one

•
DRW180A
The unit can operate in one of 3 distinct modes by simply selecting it from the display. To set one of the
three modes, press and hold button B for 3 seconds and then refer to the following table:
This mode allows both drawers to be used in fridge mode. Hence the temperature
Total is positive at +4°C / +4°C. To activate this mode, press button B repeatedly until you
fridge reach the display with both drawers at +4°C fridge-fridge. Confirm by pressing and
holding button B for 3 seconds.
This mode allows the lower drawer to be used as a freezer and hence the
temperature is negative whilst the upper drawer is used as a refrigerator and hence
Fridge /
the temperature is positive. To activate this mode, press button B repeatedly until
Freezer
you reach the display with the upper drawer at +4°C fridge and the lower drawer at
-18°C freezer. Confirm by pressing and holding button B for 3 seconds.
This mode allows both drawers to be used in freezer mode. Hence the temperature
is negative. To activate this mode, press button B repeatedly until you reach the
display with both drawers at -18°C freezer-freezer. Confirm by pressing and holding
Total
button B for 3 seconds.
freezer
To keep food at low temperature (-18°C), it is best to use the lower drawer.
•
DRW70A
The unit can operate in one of 2 distinct modes by simply selecting it from the display. To set one of the
three modes, press and hold button B for 3 seconds and then refer to the following table:
This mode allows the drawer to be used in fridge mode. Hence the temperature is
Total positive at +4°C. To activate this mode, press button B repeatedly until you reach
fridge the display with the set point at +4°C fridge. Confirm by pressing and holding button
B for 3 seconds.
This mode allows the drawer to be used in freezer mode. Hence the temperature is
Total negative -18°C. To activate this mode, press button B repeatedly until you reach the
freezer display with both drawers at -18°C freezer. Confirm by pressing and holding button
B for 3 seconds.
If no mode has been confirmed after 60 seconds, the system will confirm the last mode shown on the
display.
You can change the mode at any time.
The time to reach the new set temperatures depends on a range of issues such as, environmental
factors, drawer load, etc.
When switching from Total fridge to Total freezer, the time to reach the new temperature can be
quite long (8-12 hours).
7.4

Changing the temperature setting

When setting up the modes, pre-defined temperature setpoints have been set to optimise the unit's
automatic operations.
It is possible, however, to change these settings using the arrows C and D.
51
EN