Powering On - Vitrifrigo DRW Sereis Installation Use And Service Manual

7 POWERING ON

Once installation has been completed, check the continuity of the earth circuit and carry out all the
electrical safety tests provided for by current regulations. Protect and adequately block the cables to
avoid any risk of accidentally pulling the cable which could disconnect it or which could cause it to come
into contact with a hot part of this appliance (or another one) at a temperature over 50°C or with a sharp
part. If the power cable is damaged, it must be replaced by the manufacturer or by the manufacturer's
technical service centre or, in any case, by a person similarly qualified, in such a way as to prevent any
risk.
•
Make sure that all the packaging materials have been removed.
•
Test all piping to make sure that there are no leaks.
•
Check all the electrical connections.
•
Check that the drawer can be removed from the appliance.
•
Check that the door can be closed properly.
Before putting any food into the refrigerator, carefully clean the inside with warm water and bicarbonate
of soda.
Motor protection time. The appliance is equipped with a motor protection control which starts the
compressor only after 3 minutes from the last power on. This also happens after any interruption in the
electrical supply, whether voluntary or involuntary (a blackout).
Fig. 7.1
To avoid excessive condensation in the refrigerator, cover liquid products and let hot products cool
before putting them into the refrigerator.
To reduce cooling time, only put previously cooled foods into the refrigerator. To prevent food from
drying out, or the refrigerator assuming an undesirable smell, store food in sealed containers,
separately.
To divide food inside the drawers, there is a railing on
which two sliding partitions are installed in the direction
indicated by the arrows.
The maximum storage capacity for the drawers is 70
Kg
Do not open the drawers more than necessary.
49
EN