Table of Contents
Advertisement
7800 and 8200 Series Mortise Lock
Used with Sectional Trim and V Series Indicators
Installation Instructions
2
Indicator Variants
Depending on function and option ordered,
indicators are provided in the following variations,
these instructions detail how to install with
cylinder, however other variations follow similar
instructions. (Figure 1)
Contact factory for any questions.
3
Lock set configuration
To set function of multi-function lock or to re-hand, see instructions on lock body.
4
Rehanding Indicator (if required)
Verify hand and bevel of door. (Figure 2)
LH
Left Hand
Hinges Left
Open Inward
Note:
Stand on outside of locked door when determining door hand.
Next, verify inside and/or outside indicators are handed correctly,
using Spindle Cam Position chart. (Figure 3) If they are handed
correctly, skip to Step 5 "Prepare Door".
If they are not handed correctly:
1. Remove retaining pad and spindle cam from
assembly. (Figure 4)
2. Position spindle cam in correct direction for
door hand. (Figure 3)
Important:
•
3. Slide spindle cam post into correct slot of display
slide. (Figure 4)
4. Re-seat retaining pad into original position.
5. Return indicator to the vacant/unlocked position for installation.
1-800-727-5477 • www.sargentlock.com
Copyright© 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
LHRB
RH
Left Hand
Right Hand
Reverse Bevel
Hinges Right
Hinges Left
Open Inward
Open Outward
Figure 2
For thumbturn indicators, make sure thumbturn
is positioned in the 12 o'clock direction as
shown. (Figure 5)
Cylinder - For
Thumbturn -
installation
For installation
on inside or
on inside of
outside of
door.
Spindle Cam Position for Locks with Deadbolt (*and 56 function)
Outside Indicator
Inside Indicator
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
Spindle Cam Position for Locks without Deadbolt (*except 56 function)
Inside Indicator
Outside Indicator
Figure 4
3
No input /
Coin Turn - For
installation
blank - For
on outside of
installation
door.
on inside or
door.
outside of
Figure 1
Door Hand: RH / RHRB
Inside Indicator
Door Hand: LH / LHRB
Outside Indicator
Door Hand: RH / RHRB
Outside Indicator
Door Hand: LH / LHRB
Inside Indicator
Figure 3
Display
slide slot
Thumbturn
position
Spindle
cam
Retaining
pad
Figure 5
door.
A8257C 03/20
Advertisement
Table of Contents
