Lock Led Indications - Sargent Profile Series Installation Instructions Manual

Profile Series v.N2 Mortise Lock

Lock LED Indications

8
1 Lock Normal Operation LED indication
The lock has three LEDs that support an optical scheme with red, yellow and green.
The indication scheme is described by the figures below:
Access granted,
EAC offline or online
Access denied,
Access denied,
Lock mechanism is
blocked when closing
maintenance required
Time to replace the battery
Battery reached end of life,
NOTE: When the lock mechanism is blocked (lock jammed) the knob must be turned to release it.
The "Error in lock" indication is also shown instead of the POST flashes if the battery is not accepted
as new after a power¬on¬reset.
2 Lock Maintenence LED Indication
Some special LED indication schemes are used during lock maintenance actions:
Enter configuration
Card read
(configurable)
EAC online
EAC offline
Error in lock,
lock disabled
Fig. Lock Normal operation LED indication
mode
Fig. Lock maintenance LED indication
One yellow flash (.25 second)
One green flash (1 second)
One red flash (1 second)
Three red flashes (.5 s each)
Continuous red flashes blocked when
closing (.125 seconds every 1 second)
Ten red flashes (.125 s each), maintenance
required; repeated if lock can't close
Continuous yellow flashes
(.25 seconds every 5 seconds)
Continuous red flashes of life,
(.25 seconds every 5 seconds)
Five yellow flashes (.125 s each)
1-800-810-WIRE • www.sargentlock.com • A8078A 15