Rf Technology Lock - Sargent v.G1.5 Installation Instructions Manual

Step #11 – Install Inside Cover
1. Attach inside cover to escutcheon making
sure to line up tabs with retaining
slots in cover.
2. Secure with security screw using
provided security tool (Fig. 11).
For information about the RF Technology versions (G1-TU, G1-TP, G1-TA),
For information about Wiring, refer to "Wiring Options" starting on page 21.
Step #12 – Install Rail Assembly
Attach rail assembly according to Exit Installation Instructions A6770.

RF Technology Lock

8
Installation for the RF Technology Lock for
G1-TU, G1-TA, G1-TP is, for the most part,
installed as described in section 6.
In addition:
The antenna board must be carefully
moved to access the upper through-bolt
screw. Care should be taken to prevent
damage to the antenna retaining tabs
during this process (Fig. 12).
1. Press the two tabs away from the
antenna board and lift the board
off the mounting posts.
2. Insert the flat head through-bolt and
secure the escutcheon in place.
3. After tightening the top through-bolt,
replace the antenna board by placing
it on the mounting posts and pressing
into the retaining tabs.
21 1-800-810-WIRE • www.sargentlock.com • A7856C
refer to "RF Technology Lock" in next section.
For information about the Testing,
refer to "Operational Check" on page 26.
Antenna
Board
Mounting
Posts
Profile Series v.G1.5 Mortise Exit Device
Tabs
Retaining Slots
Controller
Assembly
Fig. 11
Flathead
Through-bolt
Antenna
Board
Antenna Board
Retaining Tabs
Fig. 12