Copyright © 2016, Juniper Networks, Inc.
Figure 12: Craft Interface in an EX9208 Switch
1
8
1—
Host subsystem LEDs
2—
Fan LEDs
3—
Power supply LEDs
4—
Minor alarm LED
5—Major alarm LED
Figure 13: Craft Interface in an EX9214 Switch
1
1—
Power supply LEDs
2—
Fan LEDs
3—
Host subsystem LEDs
4—
Minor alarm LED
5—Major alarm LED
NOTE:
You can install a line card or a Switch Fabric module (SF module) in
slot nine—labeled
depending on the hardware installed in that slot.
NOTE:
At least one Switch Fabric module (SF module) with a Routing Engine
module (RE module) must be installed in the switch for the craft interface
to obtain power.
The craft interface has the following components:
Host Subsystem LEDs on page 22
Fan LEDs on page 22
Power Supply (PEM) LEDs on page 23
Chapter 2: Updated Common EX9200 Topics
2
3
9
6—
Alarm cutoff/lamp test button
7—
Alarm relay contacts
8—
Switch Fabric LEDs and control buttons
9—
Line card LEDs and control buttons
2
3
4
8
6—
Alarm cutoff/lamp test button
7—
Alarm relay contacts
8—
Switch Fabric LEDs and control buttons
9—
Line card LEDs and control buttons
2 | 6
. The corresponding LED displays information
4
5
6
7
5
6
7
21