Juniper EX9200 Manual page 80

Hardware Topics for Aloha Line Card
Table 26: Software Support for SFP+ Passive Direct Attach Copper Cables for EX Series
Switches (continued)
Switch Software Support Added
EX4550-32F-S switches Junos OS Release 12.3R5
EX8200 8-port SFP+ Junos OS Release 10.0
line cards
(EX8200-8XS)
Junos OS Release 10.3
EX8200 40-port SFP+ Junos OS Release 10.3
line cards
(EX8200-40XS)
Junos OS Release 11.1
64
NOTE: We recommend that you use only SFP+ DAC cables purchased from
Juniper Networks with your Juniper Networks device.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
The cables are hot-removable and hot-insertable: You can remove and replace them
without powering off the switch or disrupting switch functions. A cable comprises a
low-voltage cable assembly that connects directly into two SFP+ ports, one at each end
of the cable. The cables use high-performance integrated duplex serial data links for
bidirectional communication and are designed for data rates of up to 10 Gbps.
Table 27 on page 65 describes the cable specifications.
Cable Length
3 ft (1 m), 10 ft (3 m), 16 ft (5 m), and 23 ft (7 m)
3 ft (1 m), 10 ft (3 m), and 23 ft (7 m)
16 ft (5 m)
3 ft (1 m), 10 ft (3 m), and 23 ft (7 m)
16 ft (5 m)
Copyright © 2016, Juniper Networks, Inc.