Line Card Components; Ex9200-4Qs Line Card; Figure 19: Ex9200-40T Line Card - Juniper EX9200 Manual

Hardware Topics for Aloha Line Card

Line Card Components

Related
Documentation

EX9200-4QS Line Card

32

Figure 19: EX9200-40T Line Card

1— Ejector lever
2— Line card LED
3—MIC LED
You can use the
show version
switches loaded on the switch.
The EX9200-40T line card has:
40 10/100/1000BASE-T ports that support RJ-45 connectors
Line card LED—An LED labeled
Card LED in an EX9200 Switch.
MIC LED—An LED labeled
"Modular Interface Card LED in an EX9200 Switch" on page
Network port LEDs—Two LEDs on each network port that indicate the link activity and
status of the port. See "Network Port LEDs in an EX9200 Switch" on page
Line Card Model and Version Compatibility in an EX9200 Switch on page 35
Pluggable Transceivers Supported on EX9200 Switches on page 37
Installing a Line Card in an EX9200 Switch
Handling and Storing Line Cards in EX9200 Switches
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that you can
install in the line card slots on the front of the switch chassis. Line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions.
This topic describes:
Line Card Models on page 33
Line Card Components on page 33
4— LEDs for 10/100/1000BASE-T ports
5— 10/100/1000BASE-T ports
command to see the version of Junos OS for EX Series
indicates the status of the line card. See Line
OK/FAIL
on each MIC indicates the status of the MIC. See
OK/FAIL
5.
15.
Copyright © 2016, Juniper Networks, Inc.