Ex9200-6Qs Line Card; Line Card Models; Figure 21: Ex9200-6Qs Line Card; Table 19: Ex9200-6Qs Line Card - Juniper EX9200 Manual

Hardware Topics for Aloha Line Card

EX9200-6QS Line Card

Line Card Models

34
Installing a Line Card in an EX9200 Switch
Handling and Storing Line Cards in EX9200 Switches
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
This topic describes:
Line Card Models on page 34
Line Card Components on page 35
Table 19 on page 34 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.

Table 19: EX9200-6QS Line Card

Model Description
EX9200-6QS A line card with six 40-Gigabit Ethernet
quad small form-factor pluggable plus
(QSFP+) ports, each of which can
house 40-gigabit quad small
form-factor pluggable plus (QSFP+)
transceivers and 24 10-Gigabit Ethernet
small form-factor pluggable plus
(SFP+) ports, each of which can house
10-gigabit small form-factor pluggable
(SFP+) transceivers
See Figure 21 on page 34.

Figure 21: EX9200-6QS Line Card

1— Ejector lever
2— Line card LED
3— LEDs for SFP+ ports
Junos OS Release Required
14.2R1 or later
CAUTION: Junos OS Release 14.2R1
supports the EX9200-6QS line card
except for one specific configuration.
See the Junos OS 14.2R2 Release
Notes
for Known Issue PR1068396 to
determine whether that configuration
applies to your switch and which
release to use if the configuration does
apply.
4— SFP ports
5— LEDs for QSFP+ ports
6— QSFP ports
Copyright © 2016, Juniper Networks, Inc.