Compliance Statements For Emc Requirements For Ex Series Switches; Led; Table 6: Network Port Leds On Line Cards In An Ex9200 Switch-Status Led - Juniper EX9200 Manual

Hardware Topics for Aloha Line Card
Related
Documentation

Compliance Statements for EMC Requirements for EX Series Switches

16
The Status LED in 10/100/1000BASE-T RJ-45 Ethernet network port indicates the status
of one of the three port parameters. The port parameters are administrative status, speed,
and duplex mode status.
Table 6 on page 16 describes the Status LED.
Table 6: Network Port LEDs on Line Cards in an EX9200 Switch—Status

LED

LED LCD Indicator
Status LED: ADM
LED: SPD
LED: DPX
Line Card LED in an EX9200 Switch
Craft Interface in an EX9200 Switch on page 20
This topic applies to hardware devices in the EX Series product family, which includes
EX Series switches, the EX Series Redundant Power System (RPS), and the XRE200
External Routing Engine.
This topic describes the EMC requirements for these hardware devices for:
Canada on page 17
European Community on page 17
Israel on page 17
Japan on page 18
Korea on page 18
United States on page 18
State, Color, and Description
Indicates the administrative status (enabled or
disabled). The status indicators are:
Green—Administrative status enabled.
Yellow—The port is down.
Unlit—Administrative status disabled.
Indicates the speed. The speed indicators are
different in the line cards.
Unlit—10 Mbps
Green—Blinking—100 Mbps
Green—On steadily—1000 Mbps
Indicates the duplex mode. The status
indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is not set to full-duplex mode.
Copyright © 2016, Juniper Networks, Inc.