Ex9204 Switch Hardware And Cli Terminology Mapping; Table 32: Cli Equivalents Of Terms Used In Documentation For Ex9204 - Juniper EX9200 Manual

EX9204 Switch Hardware and CLI Terminology Mapping

Table 32: CLI Equivalents of Terms Used in Documentation for EX9204 Switches
Hardware
Item (CLI) Description (CLI)
Chassis EX9204
Midplane EX9204-BP
FPM Board Front Panel Display
PEM(n) One of the following:
PS 1.4–2.52 kW;
90-264 V AC in
DC 2.4 kW Power
Entry Module
Routing RE–S–EX9200-1800X4
Engine (n)
CB (n) EX9200–SCBE
Copyright © 2016, Juniper Networks, Inc.
This topic describes the hardware terms used in EX9204 switch documentation and the
corresponding terms used in the Junos OS CLI. See
Value (CLI)
–
–
–
n is a value in the range of
0–3. The value corresponds
to the power supply slot
number.
n is a value in the range 0–1.
In base configuration, only
one entry appears.
In redundant configuration,
two entries appear; one for
each Routing Engine
module (RE module)
installed in the chassis.
n is a value in the range of
0–1.
Multiple line items appear
in the CLI if more than one
Switch Fabric modules (SF
modules) are installed in
the chassis.
CB0 and CB1 stand for SF
modules.
Chapter 3: Updated EX9204 Topics
Table 32 on page
Item in Documentation Additional Information
Switch chassis "Chassis Physical
Specifications of an
EX9204 Switch" on
page 73
Switch midplane Midplane in an EX9200
Switch
Craft interface "Craft Interface in an
EX9200 Switch" on
page 20
AC or DC power supply
RE module Routing Engine Module in
an EX9200 Switch
SF module Switch Fabric Module in an
EX9200 Switch
77.
AC Power Supply in an
EX9204 Switch
DC Power Supply in an
EX9204 Switch
77