Juniper EX9200 Manual page 25

Copyright © 2016, Juniper Networks, Inc.
CAUTION: Before you slide the MIC into the slot, ensure that the MIC is
aligned correctly. Misalignment might cause the pins to bend, making the
MIC unusable.
Slide the MIC into the slot gently until it is fully seated (see
7.
Figure 8 on page 11).
Push the MIC ejector lever on the line card that is adjacent to the MIC slot in which
8.
you are installing the MIC until the MIC is seated properly.
If you are installing only one EX9200-10XS-MIC or EX9200-20F-M-MIC, install a blank
9.
cover panel over the empty MIC slot and secure it with captive screws by using the
screwdriver. Do this to protect the interior of the chassis from dust or other foreign
substances and to ensure that the airflow inside the chassis is not disrupted.
Bring the MIC online by pressing the online/offline button on the MIC by using a pin
10.
that fits the opening to the button until the
can also bring the MIC online by issuing the following CLI command:
user@host> request chassis mic fpc-slot slot-number mic-slot slot-number online
Chapter 1: New Topics
Figure 7 on page 10
LED on the MIC is lit green. You
OK/FAIL
or
9