Updated Common Ex9200 Topics; Network Port Leds In An Ex9200 Switch; Table 5: Network Port Leds On Line Cards In An Ex9200 Switch-Link/Activity - Juniper EX9200 Manual

CHAPTER 2

Updated Common EX9200 Topics

Network Port LEDs in an EX9200 Switch

Copyright © 2016, Juniper Networks, Inc.
Network Port LEDs in an EX9200 Switch on page 15
Compliance Statements for EMC Requirements for EX Series Switches on page 16
Craft Interface in an EX9200 Switch on page 20
EX9200-2C-8XS Line Card on page 25
EX9200-32XS Line Card on page 27
EX9200-40F Line Card on page 28
EX9200-40F-M Line Card on page 30
EX9200-40T Line Card on page 31
EX9200-4QS Line Card on page 32
EX9200-6QS Line Card on page 34
Line Card Model and Version Compatibility in an EX9200 Switch on page 35
Pluggable Transceivers Supported on EX9200 Switches on page 37
SFP+ Direct Attach Copper Cables for EX Series Switches on page 62
Power Requirements for EX9200 Switch Components on page 67
Each SFP, SFP+, QSFP+, CFP, and network port on the faceplate of a line card has an
LED that indicates the link activity of the port. Each 10/100/1000BASE-T RJ-45 Ethernet
network port has two LEDs that indicate link activity and status of each port.
Table 5 on page 15 describes the Link/Activity LED.
Table 5: Network Port LEDs on Line Cards in an EX9200
Switch—Link/Activity LED
LED Color
Link/Activity Green
State and Description
On steadily—The port and the link are active,
but there is no link activity.
Blinking—The port and the link are active, and
there is link activity.
Off—The port is not active.
15