Line Card Components; Ex9200-40F Line Card; Line Card Models - Juniper EX9200 Manual

Hardware Topics for Aloha Line Card

Line Card Components

Related
Documentation

EX9200-40F Line Card

Line Card Models

28
You can use the
show version
switches loaded on the switch.
The line card has:
32 SFP+ ports, each of which can house SFP+ transceivers
32 dust covers for the 32 SFP+ ports (shipped in an accessory bag)
Line card LED—An LED labeled
Card LED in an EX9200 Switch.
Network port LED—One LED on each network port indicates the link activity of each
port. See "Network Port LEDs in an EX9200 Switch" on page
The ports are divided into two port groups of 16 ports each—the ports labeled
0/7 and 1/0 through 1/7 form one port group; the ports labeled
through form the other port group. The ports in each group share 120 gigabits of
3/7
bandwidth. Thus, you can transmit up to 120 gigabits of traffic through a port group,
without packet drop.
Line Card Model and Version Compatibility in an EX9200 Switch on page 35
Pluggable Transceivers Supported on EX9200 Switches on page 37
Installing a Line Card in an EX9200 Switch
Handling and Storing Line Cards in EX9200 Switches
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that you can
install in the line card slots on the front of the switch chassis. Line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions.
This topic describes:
Line Card Models on page 28
Line Card Components on page 29
Table 15 on page 29 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
command to see the version of Junos OS for EX Series
OK/FAIL indicates the status of the line card. See Line
Copyright © 2016, Juniper Networks, Inc.
15.
through
0/0
2/0 through 2/7 and 3/0