Table of Contents
Advertisement
ConfigOR Setup
Launch the ConfigOR-G2 program (page 29), the program's startup screen should look like the left
screen shot below. A Not Connected message will be shown in its lower left corner
Click the down pull arrow on the right side of the COM Port window and select the COM port to be
used. Finally, click the Connect button.
A successful connection will 'gray out' the Connect button, fill in the
Gateway
windows. The message in the lower left corner will change to: Connected. Close the
ConfigOR-G2 program.
Continue at
Using the ViewOR G2 Program
Note: The IP addresses that appear in the screen shots on this and following pages are for illustration only.
on the following page.
IP Address, Subnet Mask and
40
Advertisement
Table of Contents
