Demonstration Program - NDS ConductOR User Manual

Demonstraton Program
The included Demonstration program (NDS 58D0023) is intended for demonstration, installation
and testing of the ConductOR. It may not be used in an OR while any clinical procedure is in
progress.
Setup:
1. Connect a straight through serial cable (NDS 35D0003 or equivalent) from the PC's serial port to the
RS-232 IN connector.
2. Connect one or more signal sources to the appropriate inputs.
3. Connect one of the outputs to a compatible monitor.
4. The ConductOR and the PC should be turned on.
Usage:
The demonstration program is designed to run on a 1280 x 1024 or larger monitor.
Click the Windows Start button, then click All Programs. Select: NDS Surgical Imaging, then select and click
DemoOR-G2 to launch the demonstration program. The program's startup screen is shown below. The
four right hand primary / secondary input labels will be blank until the program is communicating with the
ConductOR.
Click the green button in the lower right corner to start communications with the ConductOR.
The Com Port and Address selection windows are displayed.
Select the Com Port using the + or - buttons to the right of the Com Port window.
If the address isn't 0, then set it to 0 using the + or - buttons to the right of the Address window.
After selecting the Com Port and Address click the Accept Selections button.
Continued on the following page.
45