NDS ConductOR User Manual page 56

Problem
No video output
Data is not streamed to
the network
Network connectivity
49
Test
Output Module confidence test:
1. Turn the ConductOR off.
2. Connect a display to each Output Module.
3. Verify that each display is turned on and that its input type matches the
output type of the output module to which it is connected.
4. Turn the ConductOR on.
5. In approximately 20 seconds, the Startup Screen (see page 8) should
appear on each of the connected displays. If the Startup Screen appears on
all displays, then the Output Modules are good.
Touch the Select Inputs icon, then touch the Identify button. A 1 will appear on
the display connected to output 1, 2 will appear on the display connected to
output 2 and 3 will appear on the displays connected to outputs 3 and 4.
1. Connect a compatible display to OUT 1, select
LAN input. Input selection is described on page 11. The test pattern shown
below should appear on the display. If it does not, then data streamer is not
running.
2. Review Streaming Video and Audio
that a network connection has been established.
3. On the IP Streaming screen verify that the Mode is Transmit. If the
'Streaming subsystem is initializing' message appears and does not clear in
30 seconds, turn the ConductOR's power off and on.
Network connectivity test:
1. Verify that the ConductOR is turned on and connected to your network.
2. From the front panel select IP Streaming the IP Address window should
hold an IP address.
3. From a PC connected to the same network as the ConductOR, click the start
button then select: All Programs > Accessories > Command Prompt.
4. Type ping and the IP address from the IP Address window. The response
should be as shown in the screen shot below. Note: Your IP address may be
different from the IP address in the screen shot.
Display 1, then select the
section that starts on page 36. Verify