Table of Contents
Advertisement
When the program is communicating with the ConductOR, the green button will be illuminated.
Display 1 will be the active display with a red ring surrounding it.
One of the primary input buttons will be illuminated.
A label will be added each of the four right primary and secondary inputs that has a corresponding
input module installed.
Clicking the Identify button displays a 1, 2 or 3 in yellow on each of the monitors connected to the
ConductOR. The monitor connected to OUT 4 will display a 3.
The program's
Help
file may be viewed by clicking the NDS logo. The
Help
file contains a
Usage
section, Controller,
Scalar
and
Streamer
BIOS part numbers and an inventory of the installed input and
output modules. Note: The
Streamer
BIOS is not displayed until the
Streamer
has completed its
initialization, this may take up to 30 seconds.
Continued on the following page.
46
Advertisement
Table of Contents
