Recycling - NDS ConductOR User Manual

CAUTION
1
This symbol alerts the user that important literature concerning the operation of this unit has
been included. Therefore, it should be read carefully in order to avoid potential problems.
This symbol warns user that un-insulated voltage within the unit may have sufficient magnitude to
cause electrical shock. Therefore, it is dangerous to make contact with any part inside the unit. To
reduce the risk of electric shock, DO NOT remove cover (or back).
parts inside.
To prevent fire or shock hazards, do not expose this unit to rain or moisture. Also, do not use this unit's
polarized plug with an extension cord receptacle or other outlets unless the prongs can be fully inserted.
The display is designed to meet the medical safety requirements for a patient vicinity device. This device
may not be used in connection with life support equipment.
Product Safety:
This product meets the medical safety requirements UL 60601-1 for U.S. National
requirements, IEC-60601-1 International Requirement and CAN/CSA C22.2 No. 601.1 for
Canadian National requirements.
North American Safety Compliance:
WITH RESPECT TO ELECTRIC SHOCK, FIRE AND MECHANICAL HAZARDS ONLY IN
ACCORDANCE WITH UL 60601-1/CAN/CSA C22.2 NO. 601.1.
EEC Safety Compliance:
These products meet the requirements of EN 60601-1 so as to conform to the Medical Device
Directive 93/42/EEC (general safety information) as amended by 2007/47/EC.
This equipment is energized from 100-240 VAC 50 / 60 Hz power source. It is the responsibility of the
installer to ensure that the equipment is installed in accordance with applicable hospital, local and national
electrical codes.
An equipotentiality post, located on the back of the equipment, may be used for the purpose of bonding
the ConductOR's chassis to other equipment to ensure that all devices are at the same potential. Any such
bond must be installed in accordance with applicable electrical codes. The equipotentiality post is shown
on the mechanical drawing found on page 3.

Recycling:

Follow local governing ordinances and recycling plans regarding the recycling or disposal of this
equipment , or contact the Electronic Industries Alliance (www.eiae.org)
ii
Refer servicing to qualified service personnel.
There are no user serviceable