Location To Location Streaming - NDS ConductOR User Manual

Location to Location Streaming

Note: The following steps assume that you are continuing from the Software Setup section.
Touch the IP Streaming icon on the Transmit unit's Home screen (page 9). When the IP Streaming
screen is displayed, select:
On the Mode row, select Transmit by touching the Transmit button.
On the Stream Source row select the Display (output) to be used as the streaming source.
On the Stream Resolution row, select the stream resolution 1080i, 720p or 480p.
The IP address is displayed in the IP Address row window should be the same as the IP address that
was assigned when you ran the ConfigOR–G2 program (page 29).
Touch the IP Streaming icon on the Receive unit's home screen (page 9). When the IP Streaming
screen is displayed, select Receive on the Mode row. Stream Source is disabled in receive mode .
Stream Resolution will be automatically set to match the resolution of the inbound stream.
The IP address is displayed in the IP Address row's window should be the same as the IP address that
was assigned when you ran the ConfigOR–G2 program (page 29).
Continued on the following page.
31