Table of Contents
Advertisement
ConductOR Overview
The ConductOR has 4 fixed inputs as shown in Fixed Inputs table below. Up to 4 input modules and up to 4
output modules may be added. The drawing on page 3 shows location of the fixed input connectors and
the input and output modules. The 24 VDC power out connector provides power, 120 watts maximum, to
an external device. The input and out modules are described on page 5.
Fixed Inputs
S-VIDEO IN A / COMP IN A
S-VIDEO IN B / COMP IN B
VGA / SOG
DVI / RGBS / YPbPr
General Information
Installation:
ConductOR units may be stacked on a equipment carrier, a surgical cart or mounted in a standard 19" rack.
Do not block the air vents.
Compatible Displays:
1. HD displays with Fiber Optic input.
2. HD displays with a DVI input that accepts signals with 720p or greater resolution.
3. HD displays with HD-SDI or 3G-SDI input.
Control Options:
The ConductOR may be controlled from:
1. Its front LCD touch panel.
2. A PC via the RS-232 port. See page 50 for serial port setup and test details. The
Commands
(P/N 60A0156) document contains a complete set of serial commands for the
ConductOR. Please contact your
Input Signal
Notes
NTSC or PAL
Only one may be selected at a time.
NTSC or PAL
Only one may be selected at a time.
VGA or SOG
Only one of these signals may be applied.
DVI or RGBS or
Only one of the signals may be applied. Maximum
YPbPr
resolution is: 1920 x 1080 progressive.
NDS sales representative
for details.
NDS Unified Serial
2
Advertisement
Table of Contents
