User Configuration - NDS ConductOR User Manual

User Configuration

Connect your PC to the ConductOR via an RS-232 cable. Verify that both are powered on. Launch the
ConfigOR-G2 program, click the Connect button and verify that Connected appears in the lower left
corner. See example on page 23.
In the User Configuration section click the List button. If less than four names appear you may add
additional names and passwords. If four names appear, then one or more of the names must be
removed before any names can be added.
Type the new user name
click the Add button to save the name and password.
A single user name
button.
All user names may be removed by clicking the Remove All button.
Close the ConfigOR-G2 program, then turn the ConductOR off and on. This writes the names and
passwords into the ConductOR's memory. The names and passwords are used with the ViewOR G2
program.
Note: User Configuration data overwrites the default user name (root) and password (admin). If all user
names are deleted, the default user name (root) and password (admin) are restored when the
ConductOR is turned off and on.
in the User Name window and its password in the Password window. Finally,
may be removed by selecting the name in the User List then clicking the Remove
44