Table of Contents
Advertisement
ZeroWire Mobile Monitor Setup
Height Adjustment of Monitor
The ZeroWire Mobile supports approximate monitor heights
as measured from the axis of the mounting plate hinge to the
floor surface ranging from 53.94" – 68.2" (137 cm - 173 cm).
To raise and lower the monitor
assembly, confirm that the
caster brake locks are applied
to
stabilize
the
ZeroWire
Mobile, then lift the release
lever and press up or down on
the upper handle.
Caution: Extend fingers
when
lowering
monitor assembly to
prevent
accidental
pinching.
Tilt Adjustment of Monitor
The ZeroWire Mobile supports approximate
monitor angles ranging from -5° – 50° measured
vertically from the axis of the mounting plate
hinge.
the
To adjust the monitor angle, first confirm that the caster
brake locks are applied, then grasp the top and bottom of
the monitor and push and pull to rotate the monitor on the
axis of the mounting plate hinge.
53.94"
(137cm)
50°
ZeroWire Mobile Monitor Setup | 15
68.2"
(173 cm)
-5°
Advertisement
Table of Contents
