ViewOR G2 Setup and Usage
Preparing the ConductOR:
Connect the ConductOR (unit) to your network then connect the network to your PC using Ethernet
cables. Turn the PC and unit on. Connect a compatible signal source to the unit's
unit's OUT 1 (see connector panel on page 3) to a compatible display. Finally, on the Home screen (page
9), touch Select Inputs icon.
On the Select Display row touch the
Touch the Change button on the Primary row.
The Primary Input screen is displayed. Touch the
should be shown on the connected display.
Continued on the following page.
Display 1
icon.
DVI 2
button. An image of the signal applied to
DVI 2
input. Connect the
DVI 2
38