Table of Contents
Advertisement
Location to Location Receive Setup
Move the RS-232 cable to the Receive unit's RS-232 IN connector (page 30). Launch the ConfigOR-G2
program, described on the previous page. Select the COM port to be used, then click the Connect button.
Click the Connect button, a successful connection will 'gray out' the Connect button, fill in the
Address, Subnet Mask and Gateway
Connected.
Note the Receive unit's
Move the RS-232 cable back to the Transmit unit's RS-232 IN connector (page 30). Launch the
ConfigOR-G2 program, select the COM port to be used, then click the Connect button.
Type the Receive unit's
Optionally, the Transmit unit's
the Remote IP Address frame. Doing so allows streaming to be initiated or terminated from the
Transmit or the Receive unit.
Click the Apply button . Close the ConfigOR-G2 program. This completes the software setup.
Establishing a Streaming Connection
windows. The message in the lower left corner will change to:
IP Address.
Close the ConfigOR-G2 program.
IP address
into the IP Address window in the Remote IP Address frame.
IP address
may be entered in the Receive unit's IP Address window in
is described on the following pages.
IP
30
Advertisement
Table of Contents
