Location To Location Transmit Setup; Location To Location Receive Setup - NDS ConductOR User Manual

Location to Location Transmit Setup

Note: The IP addresses that appear in the screen shots on this and following pages are for illustration only.
Launch the ConfigOR-G2 program, the program's startup screen should look like the left screen shot
below. A Not Connected message will be shown in its lower left corner
Click the pull down arrow on the right side of the COM Port window and select the COM port to be
used. Finally, click the Connect button.
A successful connection will 'gray out' the Connect button, fill in the
Gateway windows. A dot appears in the radio button to the left of "Use the following static IP address".
The message in the lower left corner will change to: Connected. Close the ConfigOR-G2 program.
Click the radio button to the left of
the IP Address, Subnet Mask And Gateway
static IP address" and entering the required information. Finally, click the Connect button.
Location to Location Receive
29
"Obtain an IP address
by clicking the radio button to the left of
is described on the following page.
IP Address, Subnet Mask and
automatically....". You may manually assign
"Use the following