Table of Contents
Advertisement
About This Manual
This manual is designed to assist the user with installation, setup and operation of the ConductOR and its
associated displays. A list of displays that may be used with the ConductOR is in the
section on the following page.
2
A blue numbered tab on the side of the page denotes the beginning of a section.
The functional descriptions in this manual are representative of:
ConductOR:
Part Number: 90T0007
Firmware:
Scalar:
58J0039 Version A and later.
Controller:
58C0101 Version A and later.
Manual Part Number 60G0368 Rev C
Intended Use and Contraindications
Intended Use:
This device is intended for use in a medical environment to route high quality video and graphic images .
Contraindications:
This device may not be used in the presence of flammable anesthetics mixture with air, oxygen or nitrous
oxide. Also, it is not intended for life support applications.
Condition
End user cannot view the video
data from a connected video
source
External control failure
ConductOR cannot be powered
on.
For mission critical applications, we strongly recommend that a replacement unit be immediately available.
1
Possible Cause
Incompatibility with video source
equipment.
RS-232 communication failure.
Defective internal power supply
Compatible Displays
Mitigation
When video source equipment is
connected to the ConductOR, the end
user must verify that video is passed
from the video source through the
ConductOR and is displayed correctly
on the connected monitors .
Control unit from front panel touch
screen.
Bypass the ConductOR by connecting
the
output of the video source
directly to a monitor.
Advertisement
Table of Contents
